CONTRACTOR / ROOF PITCH

Calculate roof pitch in seconds.

Convert rise and run to the familiar X:12 pitch, angle, slope factor and approximate sloped roof area.

FREE BROWSER TOOLNO ACCOUNT REQUIREDPHONE FRIENDLY

Roof Pitch Calculator

Calculate roof pitch as X:12, roof angle in degrees, sloped area and slope factor using rise and run. Free contractor calculator.

QUICK PITCH PRESETS
Use the same length unit for rise and run. Quantities are geometric estimates only.

Live result

Review and verify the output before sharing or using it.

Roof pitch—
Angle—
Slope factor—
Estimated sloped area—
Roof squares (100 ft² per square)—

This is a geometry calculator, not a structural or safety assessment.

How to use this tool

Instructions for this specific utility, not generic steps.

Measure the vertical rise

Rise is the upward distance over one horizontal run. Use inches for both measurements; do not substitute the diagonal rafter length for run.

Add the horizontal run

Enter the matching horizontal distance. For a traditional 6:12 slope, use rise 6 and run 12.

Review area estimates carefully

Enter a horizontal roof footprint only when you have measured it. The slope factor estimates one simple plane; valleys, overhangs and waste need separate treatment.

ALINOVA / WORKED EXAMPLE

Worked example and important checks

Example scenario

A 6-inch rise over a 12-inch run is a 6:12 roof pitch. The slope factor is approximately 1.118 and the angle is about 26.6°. If the horizontal footprint is 1,000 ft² and the roof is a single simple plane, the sloped surface estimate is roughly 1,118 ft² before waste.

Things to verify

Complex roofs must be broken into separate measured planes. This is a geometry estimate, not a quote, a material order or structural engineering advice.

Explore the related guide or tool →

Common questions

What does a 6:12 roof mean?

A 6:12 pitch means the roof rises six units vertically for every twelve units horizontally. The inputs must use the same unit.

Does this include roof valleys and dormers?

No. Sloped area is a simple planar estimate based on a horizontal footprint. It excludes openings, waste and complicated geometry.

Is it a structural design tool?

No. It provides geometry only. Use approved plans and qualified professionals for structural design and safe work.

ROOF GEOMETRY / EXPLAINED

Understand the difference between pitch, angle and roof area

Roof pitch describes a rise over a horizontal run; roof angle measures that slope in degrees. Neither is the diagonal rafter length. Keeping these measurements distinct helps avoid accidental overestimates when ordering materials or comparing plans.

Compare two sample roofs

A 4:12 roof rises four inches for twelve horizontal inches. Its slope factor is approximately 1.054, so a simple 500 ft² horizontal rectangle covers roughly 527 ft² of roof surface. A 9:12 roof has a factor of 1.25, so the same 500 ft² footprint would have around 625 ft² of sloped surface.

These figures assume one simple plane and no openings, overhangs or waste. The factor converts horizontal area into sloped area; it does not predict labor costs or the number of material bundles.

How to avoid a bad estimate

  1. Measure rise and horizontal run in the same unit.
  2. Enter horizontal footprint area, not an already sloped surface measurement.
  3. Split valleys, dormers and different-pitch sections into separate measurements.
  4. Check waste, overlap, underlayment and edge details using manufacturer guidance and the job plan.

Do not climb onto an unsafe roof solely to collect measurements for this tool.

What the result cannot decide

The angle and slope factor are geometry calculations. They cannot confirm whether a particular roof framing design is safe, compliant or appropriate for your climate. Consult a qualified professional for structural decisions. For ground-level material estimates, see the concrete volume calculator; the broader list is under contractor tools.

More tools for your next task

Explore related ALINOVA utilities without leaving this domain.